Fixing Error Code 228 on Your Lennox® Furnace

Not sensing any heat and noticing error code 228 from your Lennox® furnace?

This shows your heating system couldn’t regulate its pressure switch before launching. As a consequence, your system will not run for your safety.

Repairing or replacing this part is a task for the technicians at Neal Harris Service Experts in Kansas City. Our NATE-certified technicians are among the best in the industry. They’re well-qualified to handle all of your heating needs, including repairing a furnace error.

We want you to be thoroughly satisfied with our quality furnace repair in Kansas City. That’s why we back it with a 100% Satisfaction Guarantee* for a year.

How a Pressure Switch Works

This part plays a critical part as your furnace prepares to heat your home.

Here’s what happens after your thermostat’s call for heat:

  • Your furnace’s control board begins running the draft inducer blower motor. This pushes out combustion gases from the heat exchanger and moves in new gas and air so the burners can fire.
  • When the pressure switch senses that plenty of air is being pulled into the burners, it closes and tells the control board to ignite the furnace.
  • Your furnace ignites and creates heat.

What Happens When a Pressure Switch Malfunctions

When your pressure switch isn’t operating the way it should, you’ll likely hear the fan start and the switch clicking a couple times before the furnace turns off completely. When a part isn’t functioning right, your furnace will turn off for your safety.

Your furnace will tell you something is wrong with a red flash from its indicator light, which it uses to display error codes. It uses this red light to flash code, like Morse code.

You may notice fast flashes or an alternating slow flash as it communicates a fault code.

Estimated Repair Cost for Furnace Error Code 228

Before replacing the switch, your Neal Harris Service Experts tech will investigate other parts of your furnace first. A handful of other issues can also cause the error code, like a clogged vent or cracked hose.

The bill to fix your furnace depends on the issue with it and how long it takes to fix it.

If your pressure switch needs to be replaced, you can plan to pay between $40 to $350.

Start with the Experts at Neal Harris Service Experts

If you should have furnace repair, trust the technicians from Neal Harris Service Experts to check out the fault code and fix the situation to your satisfaction.

Call us at 816-787-0500 or schedule an appointment online today.